|VPL Microcontroller code|
This section gives an introduction on a specific hard- and software setup that is used in conjunction with the Curvave Viewer for interfacing the cylindrical CURVACE sensor. In this setup we use an intermediate readout board which connects to the cylindrical CURVACE and a PC.
This setup consists of three hardware components each running a specific software:
The readout software on both controllers of the cylindrical CURVACE sensor together read the columns of ommatidia and transfer the data over an SPI connection. Details and source of this controller code is currently not available.
We present to processing software implementations for this readout board.
The Visualisation software performs the configuration and readout of sensor data from both CURVACE controllers, fuses the data in a single frame, performs bias removal and transfers the visual data with a robust transmission protocol to the PC
The Optic Flow software performs the same intitial operations (configuration, readout, fusion and bias removal). The visual data itself is not transferred to the PC. Instead the software computes optic flow information and transmits this data to the PC.
The Universal software features capabilities for visualisation as well as optic flow with configurable optic flow parameters.
All readout board software implementations are available withing the Visual Processing Library.
|Last Updated on Thursday, 14 February 2013 12:36|